The Konica EYE is a Half-frame 35mm camera with a 30mm F1.9 lens. The Shutter on this one is bad, camera was $15 on Ebay.
Remove the Body cover down and baseplate.
Four screws hold the lens plate into the Body. The glue holds them in tight, you need a good screwdriver to get them out. I used a WIHA.
The plate is an integral part of the Focus mechanism, and is held in by studs. I did not remove the plate from the lens, chose to tape up the lens to protect it while cutting down to size. Dremel Time.
Use a file to get down to the ballpark. I dropped the plate into a 52->55 step-up ring to protect against sharp edges.
C-Mount from a no-name 25/1.8 TV lens, and a shim from a Jupiter-8 to set infinity focus.
On the EP2 via C-Mount adapter. A J-8 Shim was used to align actual focus with the Distance scale.
Remove the Body cover down and baseplate.
Four screws hold the lens plate into the Body. The glue holds them in tight, you need a good screwdriver to get them out. I used a WIHA.
The plate is an integral part of the Focus mechanism, and is held in by studs. I did not remove the plate from the lens, chose to tape up the lens to protect it while cutting down to size. Dremel Time.
Use a file to get down to the ballpark. I dropped the plate into a 52->55 step-up ring to protect against sharp edges.
C-Mount from a no-name 25/1.8 TV lens, and a shim from a Jupiter-8 to set infinity focus.
On the EP2 via C-Mount adapter. A J-8 Shim was used to align actual focus with the Distance scale.